REVOLVER

Low Profile, Small OD Pipe & Tube Weld Scanner

Simplicity is the key with the Revolver, you simply select the band and wedge size as required, and within minutes you are ready to scan; no complex setup or templates are required, just snap the scanner on the pipe and scan away. All Revolver components are machined from high grade aluminum and have an anodized finish to ensure long life and durability. Users can configure the Revolver for a single side phased array inspection or dual for complete weld coverage. The encoder used is rated to IP68 and is designed to operate in many types of industrial conditions. The Revolver Scanner was designed to inspect small diameter pipe/tube welds, ranging from 0.80” inches to 4.50” [20mm-115mm], and has a low profile height to operate between obstructions as low as 0.625” [16mm], such as boiler tube inspection.

FEATURES

10 unique bands covering a range of pipe sizes from 0.8″ (20.3 mm) to 4.5″ (114.3 mm)
Uses Olympus A15 phased array probes which include 11 wedge pairs ranging from 0.80” to 4.5″ OD diameters and also a pair of flat wedges
Modular design
Excellent for small diameter pipe inspection such as boiler tube inspection
Ultra-small size for limited access and operates within 0.75″ (19 mm) of pipe clearance
Scans at up to 200°F
High resolution encoder (<0.001 inch)
Urethane wheels – prevent slipping and hold
Self-adjusting, spring loaded wheel assembly for tight probe/wedge contact to the surface
Proudly designed, manufactured and assembled in the USA
Works with ProScan, Omniscan, TD Scan, M2M, GE, Zetec, VEO, and more