aut-solutions-standard-calibration-blocks

ASME PIPE STANDARDS

For angle beam testing on curvatures below 20″ diameter

ASME Basic Calibration Block – Pipe Kit, meets the requirements of ASME Section V, Article 4, Fig. T434.3, containing schedule 40 carbon steel piping with axial and circumferential notches. Diameters: 2″, 3″, 4″, 6″,8″, 10″, 12″, 14″, 16″, 18″, 20″. Each block comes with protective case and certification.

IIW-type-2 - UT Calibration Block

IIW TYPE 2

For angle beam calibrations

1018 carbon steel block. Nickel coated to protect against rust. Comes with protective case and certification.

rompas-and-dsc UT Calibration Block

ROMPAS & DSC

For angle beam calibrations

1018 carbon steel block. Nickel coated to protect against rust. Comes with protective case and certification

step-blocks UT Calibration Block

STEP BLOCKS

For straight beam calibrations

1018 carbon steel blocks, 4-Step block is 1″ thick with steps at 0.25″, 0.50″, 0.75″ & 1.0″. 5-Step block has steps at 0.10″, 0.20″, 0.30″, 0.40″ & 0.50″. Nickel coated to protect against rust. Comes with protective case and certification